Construction & Engineering Vehicles
The listed 8×4 truck-mounted crane configuration is intended for lifting and placing loads where a road-going chassis and onboard crane are required. It may suit construction, site logistics and equipment-handling plans in Ghana. Before selection, confirm the chassis identity, crane model, load chart, working radius, stabilizer footprint, deck layout and site conditions against the actual job.
8x4; source-listed 12–16 t crane range; hydraulic outriggers; 12.75 m³ cargo box
Listed figures describe a source configuration. Final chassis identity, lifting chart and order specification should be confirmed before quotation.
At a glance
Performance and evidence
Independent test or engineering documents are not recorded for this configuration. Ask for the test conditions and supporting files before relying on these figures.
Project planning
| Source-listed item | Planning meaning | Calculation conditions | Factors to check |
|---|---|---|---|
| Crane capacity12–16 t (source-listed range) | Use this only as an initial capacity band; the listing does not state the lift available at every working radius. | No per-radius lift calculation is available. Use the selected crane model's load chart and final boom and stabilizer configuration. | Working radius, boom extension, stabilizer span and setup, and ground conditions must be checked. Obtain the final crane load chart for the required radius and boom extension; confirm stabilizer span and ground conditions. |
| Maximum lifting height16–18 m (source-listed) | Use this range only for early clearance and reach discussions; it is not a verified working envelope. | No verified working-envelope calculation is available. Confirm the measurement basis and final crane model and boom arrangement. | Crane model, boom position and extension, stabilizer setup, and site clearance affect the usable reach. Confirm the selected crane model, measurement method, boom position and actual hook height. |
| Gross vehicle weight31,000 kg (source-listed) | GVW is not payload or lifting capacity; it is a vehicle-mass reference for preliminary planning. | Treat 31,000 kg only as the source-listed gross vehicle weight; verify the completed vehicle's plated mass and axle-load data. | Final chassis and equipment build, vehicle loading, axle distribution, and applicable Ghana road limits must be checked. Verify the final plated mass, axle loads, mounted equipment and Ghana road requirements. |
| Cargo box dimensions8,500 × 2,500 × 600 mm (source-listed) | Use these dimensions as a preliminary deck-fit reference, not a payload rating. | Use the listed dimensions only as a preliminary deck-fit reference; they do not confirm usable deck area or payload. | Crane mounting footprint, final deck layout, tie-down provision, load distribution, and payload limits must be checked. Confirm usable deck space after crane installation, load distribution, tie-down points and payload limits. |
| Overall dimensions12,000 × 2,550 × 3,980 mm (source-listed) | These listed dimensions can inform an initial route and site-clearance review. | Use the listed dimensions for preliminary route screening only; confirm the final vehicle's travel dimensions. | Final mounted equipment, route width, overhead clearance, turning space, and local restrictions affect route suitability. Check the final build dimensions against route width, overhead clearance, turning space and local restrictions. |
Application planning
Ghana truck-mounted crane procurement and engineering configuration planning.
Procurement notes
Before you specify
Compare configurations
Prepare a project brief
Share your routes, working conditions and target-market requirements so the final vehicle configuration can be checked against your project.
Request a quoteProduct information
This listing is an initial reference for construction, site logistics and equipment-handling projects. Crane selection should be based on the actual load, working radius, boom extension, required hook height and stabilizer position—not on the headline capacity range alone.
Confirm the VIN and chassis plate against the final build sheet, obtain the selected crane model's load chart, and check axle loads, installed equipment, route dimensions and applicable Ghana requirements. Manufacturer authorization and factory or third-party inspection arrangements are not confirmed in this listing; verify them with the contracting seller before ordering.
The listing provides six gallery images; their rights status and exact match to the final vehicle build have not been independently verified.